PCWI Coating Thickness Standard

Product Codes

0119, 0120, 0525

$$POA

Calibration standards are a benchmark for checking and calibrating your Coating Thickness/Paint gauges and for your Quality Assurance Coating Procedures. Complies with the requirements of Australian Standard AS3894.3-2002. For calibrating and checking the accuracy of all coating thickness gauges/instruments. Ferrous and Non-ferrous Coating Thickness Standards show both combined imperial/metric ranges, with plate sizes from 6µm to 12.5mm. Supplied with NATA Endorsed Certificates and recertification is available. These International Standards are Proudly Manufactured in Australia by PCWI.

PCWI Measured Calibration Films

Product Codes

0115, 0116, 0117, 0118

$$POA

These Calibration Films are available in Through-colour or Clear (the colour will not scratch off like colour-painted films). PCWI Measured Calibration Films are a Benchmark for Calibrating your Coating Thickness gauges and for your Quality Assurance (QA) Coating Procedures. Complies with the requirements of Australian Standard AS3894.3-2002. Also for calibrating and checking the accuracy of digital coating thickness gauges and instruments (not for manual magnetic gauges). PCWI Measured Calibration Films are available in Working Films sets and Certified sets. They are available in various sizes of your choice. These Films are a low cost alternative to the Calibration Standards, although not in the long term as they cannot be recertified.  Only Certified Films Sets are supplied with NATA Endorsed Report

Australian Zero Plates

Product Codes

0272, 0273

$$POA

PCWI Australian / International Zero Plates.
These Plates are used for setting a Benchmark zero on your Digital Coating Thickness / paint Gauge, and for your Quality Assurance QA Coating Procedures. These are made as Ferrous (steel), or Non-ferrous (aluminium). Manufactured in Australia by PCWI.

PCWI Ultrasonic Thickness Gauge Calibration Blocks

Product Code

$$POA

PCWI Ultrasonic Thickness Gauge Calibration Blocks. A series of individual steel blocks for checking the linearity of ultrasonic thickness gauges and flaw detectors. Supplied with certification traceable to NMIA (Australia)& NIST (USA)Certified Equipment. Each block is corrosion protected by flash coating to stop surface rusting. Measured to 0.0001mm. Supplied in a sturdy PVC case. Manufactured by PCWI.